My 1987 Jaguar XJ6 swap thread
#21
Launching!
Thread Starter
iTrader: (1)
Join Date: Mar 2005
Location: Katy, Tx
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
Took a small step forward today. Installed my Kwik alternator/power steering bracket. It's simple, relatively cheap, and effective. Next comes the p/s pump and lines, intake, exhaust, fuel, etc.
#22
Launching!
Thread Starter
iTrader: (1)
Join Date: Mar 2005
Location: Katy, Tx
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
Made a little progress on the Jag today. Installed the BBK intake and got the p/s pump on. Not much, but it's starting to look like an engine again. Next up is an f-body water pump with spacers.
#24
Launching!
Thread Starter
iTrader: (1)
Join Date: Mar 2005
Location: Katy, Tx
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
I haven't put the hood back on, but it almost fit with the truck alt bracket and intake. This intake is roughly the same as an LS1/LS6 intake, and the alternator bracket is about 5" shorter. I shouldn't have any clearance problems at all. The mechanical fan is going in the trash, so I wasn't worried about it, but when I had the hood on, the hood hit the intake and alt bracket, but wasn't very close to the fan at that point.