DoWantLS1

iTrader: (1)

How did this end up holding up? Did it work good? Looking to do this on mine now cause turbo coupe pedals are a pita to find. Is there a stop for the pedal or no need for one because the stroke is less than the max of the mc?

N20neenee

iTrader: (3)

Has anyone actually looked at modifying the 2005 and up mustang pedals to work on the fox body. They come setup for hydraulic clutch stock and look to be very similar in design to the fox pedals

vnmous97

i tried to use the 2005-2009 mustang pedal assembly
i even cut it down ... but it was too big (hitting the top of the fire wall and dash )

DoWantLS1

iTrader: (1)

I did my clutch set up just like this, 3/4 wilwood with 1.4 max throw, getting a little over 1 inch throw right now. Seems to shift alright if I push pedal and hold for a second and shift slow, but if I try to shift quicker it doesn't like it, kind of wants to grind, goes in harder. Do I need more throw? Does it have to be almost 1.4 inches for a smooth faster shift?

bttlfed98gt

iTrader: (13)

Some good info in here!

Takdashark

Vnmous do you have any pictures of the the newer pedal assembly by chance?

jvert

iTrader: (1)

I may have to try this. I was going to use ls1 brake and clutch pedals in my conversion.

Danny Danny

So I see that I have room for my nissan master but mine is in a new edge and it apears that in that same hole in my car theres a wiring harness going through it did yours have a harness going through it ?