Do f-body headers fit a 1968 chevelle with a 6.0? I thought I read that some where

 

Yes.. some have used without any problem or mod's.. other have had done some mod's to the collector to repoint them correctly.

 

Edelbrock has them as the same part#

 

Got f-bodys on my 71 chevelle and I am very happy with the fit. Like bczee said the driver side points toward the outside of the car and is a little awkward. I have about 1/4" between the pass side and the frame. Driver side no problem. I do have my engine set very far back, if it moved up then you might have some issues with the lower control arm mount. Also I am using pacesetter off-road headers and the banged up tubes on the pass were already like that when I got them and have since been fixed (may also be part of the frame clearance). Heres some pics.

 

I'm also one of the folks using F-body headers on a '69 442 with a 6.0L.







You should be just fine with them...very easy to put in!

Dave

 

are either one of you guys running an f-body pan? would like to know how much lower headers are from bottom of pan... thanx, maybe a pic or two would help me! i wanna put headers on , but trying keep max clearance as i run airbags on my Monte......

 

I am runnin the lh8/h3 pan. Don't like it. Hangs too low. The headers I got came from a guy trying to put them on a 80 Monte. He couldn't get them to fit.

 

should of re-worded that..... i have LS running already with f-body pan no problems for couple of years. im currently running stock manifolds due to fact that i can drop my car basically to floor, where crossmember touches ground. i would like to finally throw headers in, but they cannot be lower than an f-body pan(if thats possible haha)

 

anyone running these on a 64-65 a-body?