Radiator cap
Radiator cap I'm finishing up my 5.3L swap into my 88 Z31. I would like to run an inline radiator cap like this guy did with his TPI:
http://www.az-zbum.com/images/engine.z31.v8.1.jpg
As long as I bleed it fully, will there be any issues with the LSx engines and a cap that is not the highest point in the cooling system? Also, where should I put the steam lines from the heads if I run a setup like in the picture?
Thanks in advance.
http://www.az-zbum.com/images/engine.z31.v8.1.jpg
As long as I bleed it fully, will there be any issues with the LSx engines and a cap that is not the highest point in the cooling system? Also, where should I put the steam lines from the heads if I run a setup like in the picture?
Thanks in advance.
