: 
TT LS Fox
Ive got a few things done.
Intercooler mounted
Picked up some Daytons
Billet Specialties Street Lites.
15x3.5 1.75bs/15x10 6.50bs
ET DRAG 28.0/10.5-15
Flaming River Manual rack installed, Ordered some Florida 5.0 gauges, picked up a Schwanke wiring harness, and a new long block on the way.
Intercooler mounted
Picked up some Daytons
Billet Specialties Street Lites.
15x3.5 1.75bs/15x10 6.50bs
ET DRAG 28.0/10.5-15
Flaming River Manual rack installed, Ordered some Florida 5.0 gauges, picked up a Schwanke wiring harness, and a new long block on the way.
If I could do it all over again I would probably go with a big single. I like the twins and all but a single setup would just be so much easier.
Gauges are in:
Now I need to figure out everything I need for a 5 lug swap and new brakes.
I plan to just spread it out...i have room to store the car and parts, so it wont be like dropped xx,xxx all at once lol. as long as i dont get antsy ill be good. keep up the good work!
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo I'll let u know when its done.
Here's a lil update:
Turbo kit is done. Everything on the intercooler is v-banded and I only need 3 couplers. One from each compressor and one from the intercooler to the TB.
Shouldnt have any issues with blowing off any couplers. Wastegates where relocated and will dump into the atmosphere instead of back into the dp's.
New motor/heads came in awhile back.
Specs:
ERL LS2 SUPERDECK I Short block
374ci 9.5:1
Compstar crank (3.625)
Forged Compstar rods (6.2)
Wiseco forged pistons (4.070)
Darton premium sleeves
All ARP hardware including 1/2 head studs/mains
SIX bolt conversion
Coated CLEVITE bearings throughout.
KATECH C5R Timing chain and Katech Oil pump+spring
O-ringed
Heads:
Performance Induction LXR heads
245cc runners with 68cc combustion chambers
Receiver groove for o-ring
Now I just need to figure out what cam would work best.
Turbo kit is done. Everything on the intercooler is v-banded and I only need 3 couplers. One from each compressor and one from the intercooler to the TB.
Shouldnt have any issues with blowing off any couplers. Wastegates where relocated and will dump into the atmosphere instead of back into the dp's.
New motor/heads came in awhile back.
Specs:
ERL LS2 SUPERDECK I Short block
374ci 9.5:1
Compstar crank (3.625)
Forged Compstar rods (6.2)
Wiseco forged pistons (4.070)
Darton premium sleeves
All ARP hardware including 1/2 head studs/mains
SIX bolt conversion
Coated CLEVITE bearings throughout.
KATECH C5R Timing chain and Katech Oil pump+spring
O-ringed
Heads:
Performance Induction LXR heads
245cc runners with 68cc combustion chambers
Receiver groove for o-ring
Now I just need to figure out what cam would work best.
Last edited by LS1PUNK; Jan 7, 2012 at 09:09 PM.
One of my buddys once said "Twins are cool but Twice as expensive and Twice the head ache." I totally agree with him at this point.
I saw ur car out at Tx2k12, I was a bit envious that urs came together as quickly as it did.
I should have a good update on this thing here in a few weeks, we'll see.
Thanx, If I was to do it all over again I would go with a big single.
One of my buddys once said "Twins are cool but Twice as expensive and Twice the head ache." I totally agree with him at this point.
I saw ur car out at Tx2k12, I was a bit envious that urs came together as quickly as it did.
I should have a good update on this thing here in a few weeks, we'll see.
One of my buddys once said "Twins are cool but Twice as expensive and Twice the head ache." I totally agree with him at this point.
I saw ur car out at Tx2k12, I was a bit envious that urs came together as quickly as it did.
I should have a good update on this thing here in a few weeks, we'll see.