flywheel spacer

Reply Subscribe

Thread Tools

Search this Thread

Dec 30, 2011 | 07:46 AM

99VetteFRC

Thread Starter

TECH Fanatic

Joined: Oct 2011

Posts: 1,356

Likes: 2

From: Felton Pa

flywheel spacer

Anybody know the part numbers and where to get the flexplate adapters or spacers to put ls1 and 700r4 together?

Dec 30, 2011 | 08:13 AM

Clai9

Teching In

iTrader: (3)

Joined: Oct 2005

Posts: 7

Likes: 0

I used this spacer by trans-dapt.
http://www.summitracing.com/parts/TRD-0055/

Dec 30, 2011 | 09:26 AM

99VetteFRC

Thread Starter

TECH Fanatic

Joined: Oct 2011

Posts: 1,356

Likes: 2

From: Felton Pa

That part says it can only be used with transdapt bell housing adapter. I need the spacer for the flexplate to crank I think.

Dec 30, 2011 | 10:03 AM

kevin87turbot

Launching!

iTrader: (2)

Joined: Nov 2009

Posts: 205

Likes: 1

The trans-dapt part should work. You could also use TCI part number 399753PE. It's similar in design to the trans-dapt part, but is less than 20 bucks. I've used quite a few of them. :-) If you're going to use your stock flexplate, you'll have to elongate the flexplate converter holes just a bit so the converter bolts will line up.

Dec 30, 2011 | 10:48 AM

99VetteFRC

Thread Starter

TECH Fanatic

Joined: Oct 2011

Posts: 1,356

Likes: 2

From: Felton Pa

I got the flat flexplate for Christmas. From what I read the bolts will line up with the converter on that flexplate. I would like the spacer used with that flexplate.

Dec 30, 2011 | 11:57 AM

newschool72

TECH Fanatic

iTrader: (12)

Joined: Feb 2011

Posts: 1,863

Likes: 11

From: georgia

Silly me ! I thought u had to have a special flexplate and TC spacer. I used the Hughs kit with both. Got it from Pace for around 160 bucks , if i remember right.