Adapting F-Body Clutch Master to GTO T-56
#1
On The Tree
Thread Starter
Adapting F-Body Clutch Master to GTO T-56
How does one adapt the large F-Body pressure line connector to the small GTO slave connector? New slave?
Thanks!
Larry
Thanks!
Larry
#3
Either get a Fbody slave from Autozone for about $70.00 or if your gto slave is still good you can try and find someone with a junk Fbody slave maybe from a shop that does a lot of Fbody clutches and you can remove the roll pin and swap the Fbody fitting onto your GTO slave as they are otherwise identical. I am not sure if you can buy just the fitting itself.
#5
Staging Lane
iTrader: (2)
Join Date: Dec 2007
Location: Chi-Town
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
The GTO slave has a completely different angle on the mounting bracket than the F-body. The pitch was wrong and it hit way too high on the pedal. The throw was way off and the pedal only moved about 2 inches till bottom out. I had to switch to a F-body slave and knock the roll pin out to remove the line. My complete set-up was from a GTO.
#6
TECH Senior Member
iTrader: (12)
The GTO slave has a completely different angle on the mounting bracket than the F-body. The pitch was wrong and it hit way too high on the pedal. The throw was way off and the pedal only moved about 2 inches till bottom out. I had to switch to a F-body slave and knock the roll pin out to remove the line. My complete set-up was from a GTO.
For my Chevelle I used the template for the plate to mount it to the firewall/brake booster. If you can use that, you can adjust the angle by bending it to the right angle. You will also have to move the piviot point/bracket on the Pedal to get the 1" drive that the Master requires.
But not knowing what the GTO and your firewall/pedal setup is like, I'll defer to other.