LS3 E-Force conversion still wont start
Thread Starter
Teching In
Joined: Feb 2013
Posts: 10
Likes: 0
LS3 E-Force conversion still wont start Well I am still in the same boat. The car still wont start after I got my 2nd
E38 computer from PSI. The car will crank and backfire but wont start. I am getting a P0335 error code on my scanner. I have replaced the crank sensor and checked the wires back to the ECM connectors. I have 12 volts when key is on and cranking. I have fuel pressure and spark. Any ideas would be great as I am about to throw in the towel.
Thanks,
Jeff
This is a LS3 with an E-Force blower from a 2010 Camaro SS. The Harness and ECM are both from PSI. All sensors are new (Crank, cam, maf).
E38 computer from PSI. The car will crank and backfire but wont start. I am getting a P0335 error code on my scanner. I have replaced the crank sensor and checked the wires back to the ECM connectors. I have 12 volts when key is on and cranking. I have fuel pressure and spark. Any ideas would be great as I am about to throw in the towel.
Thanks,
Jeff
This is a LS3 with an E-Force blower from a 2010 Camaro SS. The Harness and ECM are both from PSI. All sensors are new (Crank, cam, maf).
