'69 Firebird Build Thread
#43
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
It's an old thread that I just came across when looking how to connect to my Spectra gm32fbi. If your still around thanks for the part #'s doing a frame off LS conversion on a 69 bird myself.
The following users liked this post:
sprech (07-01-2020)
#45
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Bryan
#46
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Hey Sprech, came across an old post of yours for your Bird where you had bought 6 series BMW seats. I am close to pulling the trigger on a pair of these, no issues with the wiring and the can bus setup, but wondering how you mounted in your Firebird. These will go in my 69 Camaro that is all apart and repainted after 22 years; I have owned it since 1990. Hope you see this, if not I will amble slowly forward with a combination of square tubing and flat steel and see what happens. Thx in advance...........
#47
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Hey there, how are you? I wish I could remember how those seats were mounted in the car, but I did not do it. I *think* they may have had minimal modification to them and the only real need was to run a power wore to the seats them selves. Just make sure if they have the integrated seat belt that you sandwich the floor board between a plate and the seat that way it doesn't tear out if there is an impact.
The following users liked this post:
G Atsma (04-01-2021)
#49
TECH Senior Member
#51
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
They appear to be from an E64 6-series. That would be around 2003-2010. The E64 is the convertible version and that is why the seatbelts are integrated into the seat because there is no b-pillar.