ford 8.8 yoke for gm u-joint
#2
TECH Enthusiast
Join Date: Feb 2007
Location: Raleigh, NC
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
You are going to need to figure out which yoke or companion flange you have on the 8.8 by measuring it and researching some of the custom driveshaft mfg websites.
#3
TECH Fanatic
iTrader: (5)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
If you're using an 8.8 (car) it likely will use a 1330 Ford or 2-4800 u joint which is 3.622" wide and has 1 1/16" cap diameter, if you are using a GM driveshaft (car) with it may need a conversion u joint that mates 1310 or 1330 GM to 1330 Ford, got that? lol… There are many ways to go and there are many conversion u joints. I just did this and am using a Mustang 8.8 driveshaft to a GM 27 spline 1310 yoke for Fbody T56. Good luck. 1-0134, 2-1569, Spicer 5-134x, google them
Last edited by 64post; 07-24-2014 at 07:12 PM.