Ls1 Swap/Wiring Harness
Thread Starter
Teching In
Joined: Dec 2014
Posts: 11
Likes: 0
Ls1 Swap/Wiring Harness Not sure if this is the right spot to post this but I have a LS swapped vehicle that I would like to do some ECU harness work. Currently the computer is located in the engine bay and I would like to move it inside as well as a wire tuck under my manifold. Im new to the electrical side of the game and kinda lost on what gauge wire to use. A friend gave me this link to purchase the wire https://www.eficonnection.com/eficonnection/Wire.aspx should I just order a bit of everything? Cut the wires then solder the new wire to each end?
Thx
Thx
TECH Enthusiast
Joined: Sep 2014
Posts: 732
Likes: 1
From: alburnett, iowa
you didnt give any info what project car is or what harness used. my advise is to untape everything to get going direction wanted then figure out wire colors/etc. When I did my truck harness alot of wires on passenger side got shortened and driver side lengthened. I was able to lengthen wires using same colors from ones shortened. I also did it 1 wire at a time.
