LQ9 to NP205 VSS help
Thread Starter
Teching In
Joined: Mar 2015
Posts: 7
Likes: 0
LQ9 to NP205 VSS help I am looking for a little help on how to set up my VSS I have a speed sensor from autometer and an autometer speedo. Here are the diagrams from autometer.
This is my speed
sensor
this is the 2 diagrams I have for the speedo.
The last picture is how I currently have it wired for when I had my big block in the truck.
I have the green and the purple wires coming from the PCM, how do I connect them to make it work?
This is my speed
sensor
this is the 2 diagrams I have for the speedo.
The last picture is how I currently have it wired for when I had my big block in the truck.
I have the green and the purple wires coming from the PCM, how do I connect them to make it work?
The ecu needs a 2 wire VSS sine wave signal.
Get a 2 wire VSS from Dakota digital, wire it as in figure 2 if you want the ecu and speedo to work. You'll need to reflash for correct speed.
Get a 2 wire VSS from Dakota digital, wire it as in figure 2 if you want the ecu and speedo to work. You'll need to reflash for correct speed.
