Gen 5 Camaro Dash Swap
Gen 5 Camaro Dash Swap So I am considering a Gen 5 Camaro Dash swap for my 72 Cutlass. I already have the Camaro console installed and I just thought it would be a better look with the dash too. My question is: Can the ignition switch and turn signals be wired to work without the BCM? I have access to the wiring diagrams. I'm currently not using the factory ECU and not looking to change
I'm hoping it would be doable since the ignition is really just being used to trigger the starter and send the key on/run signal to my Holley ECU and other electronics?
Any insight would be greatly appreciated.
Chris
I'm hoping it would be doable since the ignition is really just being used to trigger the starter and send the key on/run signal to my Holley ECU and other electronics?
Any insight would be greatly appreciated.
Chris
Last edited by csouth; Feb 4, 2020 at 01:04 AM.
