Choosing DBW parts to LS1 swap
10-10-2023, 12:03 PM
#1
Teching In
Thread Starter
Join Date: Jun 2013
Location: Finland
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Choosing DBW parts to LS1 swap I have a LS1 engine with harness and DBW throttle body from Holden Commodore VZ 2004. It didn't come with throttle relaxer module (TAC I presume) nor the pedal.
I was about to purchase those but it seems they are rare parts and not worth the try.
Then I thought why not put a Corvette C5 TAC module and pedal there but this throttle body is with 8 pin connector, so it's different than in Corvette.
I searched through my shelves and found Cadillac CTS pedal (part nr 10379038) out of GMPP LS3.
I also found a throttle body out of Suburban (I think the part nr is12629992).
Can I get these to match and with what car's TAC module? I'm not afraid of wiring since I already have just loose ends in wiring in place of TAC module.
My goal is to run this engine in E39 BMW and get the cruise control also working.
I was about to purchase those but it seems they are rare parts and not worth the try.
Then I thought why not put a Corvette C5 TAC module and pedal there but this throttle body is with 8 pin connector, so it's different than in Corvette.
I searched through my shelves and found Cadillac CTS pedal (part nr 10379038) out of GMPP LS3.
I also found a throttle body out of Suburban (I think the part nr is12629992).
Can I get these to match and with what car's TAC module? I'm not afraid of wiring since I already have just loose ends in wiring in place of TAC module.
My goal is to run this engine in E39 BMW and get the cruise control also working.
