29psiHybrid

I'm thinking about doing a LS1 swap in my Nissan 240sx and pretty much have everything figured out but I just want to get some measurements of a T56 before I round up a motor setup. Basically I'm looking for shifter centerline to bellhousing surface and/or front of crank pulley. Also bellhousing heigth and the center of the tranny heigth. Any help would be greatly appreciated!

Lostpatrolman

iTrader: (3)

Try this... http://www.sallee-chevrolet.com/BorgWarner/t56pics.html

29psiHybrid

Awesome, thanks!

29psiHybrid

Just need one more measurement. It can either be bellhousing (stock) length from tranny to motor or bellhousing surface (motor side) to center of shifter.

Lostpatrolman

iTrader: (3)

hmm... The length of an auto bellhousing is 7 inches. Not sure if they are the same size as manual bellhousing though.