need a new oil neck
Thread Starter
On The Tree
Joined: Aug 2005
Posts: 128
Likes: 0
need a new oil neck i just unwraped my new motor and the oil filler neck and cap are crushed. the pcm was also wet with trans fliud. the idiot disconnected all the lines and wires and piled them all on top.
but back to the oil neck, do i have to pull the valve cover to replace it? anyone no where in the heck to get one of these?
but back to the oil neck, do i have to pull the valve cover to replace it? anyone no where in the heck to get one of these?
they are a pain to get off.
use excessive force, or remove the valve cover and unlock the tab.
the gasket is reusable on the cover, just make sure you wipe the head clean, and wipe the gasket with a rag of vasaline to clean it and provide a good sealing surface.
use excessive force, or remove the valve cover and unlock the tab.
the gasket is reusable on the cover, just make sure you wipe the head clean, and wipe the gasket with a rag of vasaline to clean it and provide a good sealing surface.
