Spohn adjustable torque arm 3rd gen question
Thread Starter
Staging Lane
Joined: Aug 2002
Posts: 51
Likes: 0
From: Baton Rouge
Spohn adjustable torque arm 3rd gen question I bought a spohn adjustable torque arm with drive shaft loop for my LS1/4l60e swap into a 3rd gen 85 Trans Am from Third Gen Resource. The problem I am having is the transmission mount does not line up with the cross member from the spohn torque arm, it is about 2 inches off. Meaning the cross member hole is 2 inches to the rear from the transmission mount bolt. When I bought this torque arm I was told to the 700r4 model would line-up and fit the 4l60e transmission. Has anyone else had this problem? If so what did you do to fix it? Thanks in advance
Thread Starter
Staging Lane
Joined: Aug 2002
Posts: 51
Likes: 0
From: Baton Rouge
Found out today from Spohn that Third Gen Resource did send me the wrong transmission crossmember instead of the 700r4 crossmember that they said would fit the 4L60E I should have gotton the LSX/4L60E crossmember. So anyone that plans on using a Spohn adjustable torque arm with transmisson mount and driveshaft loop for a 4L60E/LS1 swap make sure you order this one.
http://www.spohn.net/product.cfm?productid=1521
http://www.spohn.net/product.cfm?productid=1521
