Anyone using a "scangauge" on there ls1 swaps?

Reply Subscribe

Thread Tools

Search this Thread

Sep 10, 2007 | 06:30 PM

Turbodewd71

Thread Starter

Registered User

Joined: Sep 2007

Posts: 1

Likes: 0

Anyone using a "scangauge" on there ls1 swaps?

I want to run a scangauge http://www.scangauge.com/ on my chevelle. Sorry im kind a newbie when it comes to the digital stuff. I know it says it hooks into a obdII port and i think thats the connection most newer cars have under the steering wheel. What would i need to make this work on my chevelle? Thanks guys.

Sep 10, 2007 | 06:38 PM

ryanvv355

11 Second Club

iTrader: (17)

Joined: Mar 2007

Posts: 756

Likes: 1

From: Hudsonville, MI

I plan on running one until i can get everything setup correctly. I had it in my suburban and it worked good, then put it in my cummins and its not very trustworthy in that so I hope it works ok in the cutlass. all you do is plug it into the obd2 port and go

Sep 10, 2007 | 07:40 PM

fouz65

TECH Apprentice

Joined: Aug 2006

Posts: 301

Likes: 0

From: Mobile AL.

Quote:

Originally Posted by Turbodewd71

all you need to do is hook up the odbII plug on the ls1. its got nothing to do with the chassis. then plug up the scangauge II and thats it. i got mine mainly for a speedo and i like the other gauges on it. i keep mine on speedo, intake temps, IGN timing and water temp. i went with it cause its the same price as a good speedo and it does alot of other stuff. get it, you will like it. only thing you might not like is there is a delay. if your going 50 mph and gas it. it takes a half a sec to go up but its not that bad. just it only updates about every second. but when it updates its right.