Where did you get your LS1 pullout? (again)
Thread Starter
On The Tree
Joined: Jul 2006
Posts: 124
Likes: 0
From: Weld, ME
Where did you get your LS1 pullout? (again) There was a thread titled something like this but I can't find it now. I reformatted my harddrive a week ago and forgot to write down my bookmarks, so I lost them. Now I can't seem to remember the few sites I had that sold pullouts. One was cleveland pick-a-part, another was tacreationsusa.com. I can't think of any of the others. I'm going to be ordering my ls1/t56 pullout tomorrow so any more sites/phone numbers would be great.
Teching In
Joined: Dec 2005
Posts: 14
Likes: 0
From: Southeast Michigan (Detroit area)
I used cleveland pick a part and was real happy with them. There is a place called Schram Auto Parts in Michigan and a place called F-Parts that I believe is in Western Pennsylvania. The best bet to search on LS1 on Ebay.
y not look into a 6.0 based engine?
they weigh like 70 lbs more than the alloy block, but they have a larger bore
and can be over bored to .030=370ci
someone will always need the 317 heads for fi, so u can sell those and get some cash back if not used,
i would recommend u rebuild the 6.0 and t56 so u can start out with a frsh start as opposed to using stuff u prolly got from enthusiasts that has been
banged on and raced
.02$
they weigh like 70 lbs more than the alloy block, but they have a larger bore
and can be over bored to .030=370ci
someone will always need the 317 heads for fi, so u can sell those and get some cash back if not used,
i would recommend u rebuild the 6.0 and t56 so u can start out with a frsh start as opposed to using stuff u prolly got from enthusiasts that has been
banged on and raced
.02$
