Sounds even better. I was looking at a set of the mids from Patriot http://store.summitracing.com/partde...46%2D1&FROM=MG and hoping they would fit after a few messages from them. But the release date keeps getting pushed back.

I like the idea of stepped mids for no ground clearance issues.

I will be running a Y into 3 inch licking out in front of the wheel.

Fred

 

Unless your dead set against stock manofolds, I would ditch the mids. They produce almost no power over the 01-02 manofolds.

Re'

 

Saw a better picture of the patriot mids and they seem to exit at a 45* right at the base of the pan

I would still like to see some mids that tuck closer to the bell housing.

Headers will still be better than stockers and look way better too.

What do you have going Phil? Nothing on the site yet,,,,,,,,,,,,,,,,,

Fred

 

Here is a photo of the ceramic coated 2in primary header. I’m going to have a 1 ¾ primary as well as the 2in primary with options for stepped header on ether application in painted or coated. Along with a set of shorty headers that are about 3 weeks out. I’m about a week or so from having the long tube headers for the public, I’ll make a post as soon as I pick up the first batch. I will have a 10-14 day special order on any of the stepped headers that are ordered.

Thanks
Phil

 

Looking good!

 

Any chance of mids vs full long tube?

 

Ill pull some dyno numbers with them after i get the first couple cars out of mock up.

Thanks
Phil

 

Awesome!!



Just in case ya'll are looking for more G-body websites, because I know it was asked, these are a few that I personally surf.

http://www.montecarloss.com/

http://www.maliburacing.com/

http://www.turbobuick.com/

http://www.g-body.org/

http://www.gbodyforum.com/