wheel stud question
wheel stud question i tried searching and couldnt find it im switching to arp 12mm X 1.5 2.5 so an inch longer then stock do i have to pull the axles to install them or no
No you don't. Just unbolt the backing plate, and remove the sensor out of the plate. Then you can slide the stuf thru the hole, tap the head past the reluctor ring and then draw the stuf into the axle with an extra lug nut and a bunch of washers. Use grease too, that will help stop the washers/lugnut from binding.
I have done it with a couple cars with no problems.
I have done it with a couple cars with no problems.
Teching In
Joined: Sep 2009
Posts: 7
Likes: 0
From: Albuquerque New Mexico
No you don't. Just unbolt the backing plate, and remove the sensor out of the plate. Then you can slide the stuf thru the hole, tap the head past the reluctor ring and then draw the stuf into the axle with an extra lug nut and a bunch of washers. Use grease too, that will help stop the washers/lugnut from binding.
I have done it with a couple cars with no problems.
I have done it with a couple cars with no problems.
