Powder Coated my Madman Front Limiters
03-25-2011, 04:08 PM
#1
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Aug 2010
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Powder Coated my Madman Front Limiters I got my new front limiters in from Madman this week. Since I didn't have much going on today, I decided to powder coat them. I have one of the $99 110v setups from Summit. I used a black texture powder and it took about an hour total. This inlcuded the "cook" time in my little oven.
Before
Taken Apart
Prepped and Taped
Finished
Close-up of the black texture. Hard to see from my shitty cell phone pics.
I used high temp tape and left room on each bracket that needed to be welded. THat way the powder coat wouldn't get all bubbled, and could get a good ground during install. Will probably paint over the welds with a shot of spray paint when they are installed.
Before
Taken Apart
Prepped and Taped
Finished
Close-up of the black texture. Hard to see from my shitty cell phone pics.
I used high temp tape and left room on each bracket that needed to be welded. THat way the powder coat wouldn't get all bubbled, and could get a good ground during install. Will probably paint over the welds with a shot of spray paint when they are installed.
