Abs delete ?
#1
Launching!
Thread Starter
iTrader: (2)
Join Date: Nov 2011
Location: STL
Posts: 275
Likes: 0
Received 0 Likes
on
0 Posts
Abs delete ?
I need to install all new lines on my car. SO I figure why not install a proportioning valve on my car. BUt I need to know what size lines from the master to the pro valve and throughout the car?
I figure 1/4 line under the car to the rear with bubble flare= metric lines
Which line on the master goes to the pro valve? Rear?
Then the front lines get teed together from the front of the master? If so what size lines from the master out.
I figure the front lines to the brakes and the rear brake lines are 3/16 with bubble flared ends.
This sound right?
Pix appreciated.
thanks
I figure 1/4 line under the car to the rear with bubble flare= metric lines
Which line on the master goes to the pro valve? Rear?
Then the front lines get teed together from the front of the master? If so what size lines from the master out.
I figure the front lines to the brakes and the rear brake lines are 3/16 with bubble flared ends.
This sound right?
Pix appreciated.
thanks
#2
i run a strange manual master with a wilwood prop for the rear & an slp linelock on the front. all lines are 3/16" with no issues & streeted daily. if you plan on a linelock, do it now. it's a pain in the **** to redo everything.
Last edited by solidws6; 12-25-2012 at 03:15 PM.
#5
not sure on under car lines. everything i did was 3/16". i cut & flared the factory lines above the motor mount. i run a manual master so it might be different from a power setup but my prop goes to the rear outlet.