6pt roll bar door bar install??
6pt roll bar door bar install?? Ive been searching for weeks on this and cant find a good example.... All the pictures i find are either of a full cage or with the door bar bending at the front end and going straight down in front of seat...
Soo can someone please show me pictures of where you mounted thr front of your door bars?
I wanna say the drivers side is going to end up on the dead pedal but pics would be greatly appreciated
Soo can someone please show me pictures of where you mounted thr front of your door bars?
I wanna say the drivers side is going to end up on the dead pedal but pics would be greatly appreciated
Launching!
Joined: May 2011
Posts: 215
Likes: 0
From: Honey Brook, Pa.
Mine has a curved bar at the front. It's welded to the floor plate comes staight up a couple inches then curves to the rear on an upward angle and that's where the door bar pivots. The plate is behind the dead pedal. Everybody that sees it thinks it is a Wolfe but was done by MS Fab in NJ yrs. ago. Sorry I don't have any pics! Larry
thats pretty much all i can find. Which makes since for upgrading to a csge later on but ill never do that. And my door bars are straight. Guess ill end up with one going through the dead pedal and other in similar location on other side
Mine has a curved bar at the front. It's welded to the floor plate comes staight up a couple inches then curves to the rear on an upward angle and that's where the door bar pivots. The plate is behind the dead pedal. Everybody that sees it thinks it is a Wolfe but was done by MS Fab in NJ yrs. ago. Sorry I don't have any pics! Larry
I took these pics when I installed Ozite carpet, so the swing outs are removed, but you can see the bar connecting to the floor as it comes up then curves back.
