armyboyatc

iTrader: (29)

I'm going to try to build an intake like this that I plan to run to a bell mouth in the opening in the bumper. I would like to know what angle tube I need to get. The rest after this I can figure out but I want this to be a measure twice and cut once kinda deal. It would make things much easier to know the angle or where I can buy this tube.

95killerz

iTrader: (10)

I would guess around 135 degrees by looking at it

RENE'S RAGE

iTrader: (96)

That not a full 90* maybe 65 to 75*???
Mock up one with some aluminum dryer duct on your car then go from there.

NHRAFORMULA00

iTrader: (2)

2 - 60 degree pieces butted together will come out the middle of the license plate on a firebird. I did this in the spring with a bellmouth on the front. I also lowered the radiator an inch and a half, and cut out a half moon on the top brace in front of the radiator for better fit.