how are you guys fixing the problem of your tranny mounted torque arm mount bending?
12-15-2005 | 03:56 PM
#21
I have a spohn tq arm with the poly front bushing.. there is no rattle from the arm. The rod ended control arms and PHB make noise, but not the tq arm. ( The tq arm went in first, and made no noise with poly bushing control arms and phb either )
The BMR piece does look nice... whatever you do, get a setup that gets the tq arm off the back of the tranny. I dont' know what gm was thinking when tey mounted the tq arm to the transmission... that's just plain stupid IMO. Way too much added stress on stuff that sees enough already.
The BMR piece does look nice... whatever you do, get a setup that gets the tq arm off the back of the tranny. I dont' know what gm was thinking when tey mounted the tq arm to the transmission... that's just plain stupid IMO. Way too much added stress on stuff that sees enough already.
12-16-2005 | 03:10 PM
#23
Originally Posted by skipjobe
It was probably your headers holding the engine up, the last time I pulled the trans the headers had to be disconnected to get the tailend to come down far enough to get to the upper trans bolts.
