Bmr Torque arm

Reply Subscribe

Thread Tools

Search this Thread

Nov 19, 2005 | 07:25 PM

#21

XpEdItIoUs

Thread Starter

10 Second Club

iTrader: (44)

Joined: May 2004

Posts: 1,658

Likes: 0

From: Phoenix, AZ

I have a problem i just installed my torque arm and the trans cross member and when i accelerate i get a vibration i set my pinion pointing down 2 degrees.

Nov 20, 2005 | 09:16 AM

#22

TwnTrboCE

TECH Resident

iTrader: (43)

Joined: Jan 2003

Posts: 920

Likes: 0

From: Dayton, OH

I run the Trak Pak on my CE and have since day one. Started out with the Trak Pak on the Formula and went low 8's with it with no issues. BMR switched us over to the Extreme at the end of last season.

Nov 20, 2005 | 08:45 PM

#23

SlickVert

10 Second Club

iTrader: (5)

Joined: Nov 2003

Posts: 1,649

Likes: 0

From: Ft. Lauderdale, FL

Check to make sure that your TQ arm is not coming in contact with your exhaust or any other part of the car. Mine at the rear attach point, the bolts were hitting on the under side of the rear seats.
Also if you set to much pinion angle it will also vibration.