Phil99vette

iTrader: (11)

Just got my rear from Moser setup for 1/2" studs. They included small and large spacers and nuts. Problem is the spacers don't sit down into the lug pocket. They are about 3/32" too big, is it normal to need to turn them down to fit properly?
Phil

DERTY

Not normally. They should just fit. Did you get the lug nuts from Weld?

GPowrie

Usualy a spacer and nut setup is for the 5/8 studs. For 1/2 you should just be using a .500 shank lug. I wounder if Moser gave you parts for 5/8 studs?

DERTY

Good point. Is the spacer the Aluminum 5/8 spacer or is it the washer for a .500 shank lug?

Phil99vette

iTrader: (11)

I'm sorry, I got the 5/8" lugs.
Phil

MADMAN

iTrader: (4)

If you have the 5/8 studs just set the wheels on the studs and put the aluminum spacers on next then the nuts. They dont fit into the holes on the wheels.