Swapped steering wheel (pics)
03-24-2007, 09:40 AM
#21
11 Second Club
iTrader: (20)
Join Date: Sep 2002
Location: Albuquerque NM - The Land of 8000ft DA
Posts: 2,686
Likes: 0
Received 3 Likes
on
3 Posts
Looks great, nice writeup!
Price for the wheel? P/N?
Was there anything additional you needed to buy for the install (other than the puller)?
I'm putting my 5" tach in the same place and it's nice to see with the new steering wheel you can see ALL the gauges.
Price for the wheel? P/N?
Was there anything additional you needed to buy for the install (other than the puller)?
I'm putting my 5" tach in the same place and it's nice to see with the new steering wheel you can see ALL the gauges.
03-24-2007, 11:00 AM
#22
TECH Resident
Join Date: May 2005
Location: 8000DA Land
Posts: 983
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by JL ws-6
you can take the LED out, and put a regular diode in place if it and the dash would never know... you just have to get a meter and check the polarity of the diode you took off and put one in place if it the same way. Just get a regular diode, not a LED diode, and make sure that nothing is shorted out when soldering on the board, you don't overheat it, etc.etc.
Being that I'm an electronics guy, I can tell you , the only differnence from an LED and a regular diode is that one emmits light... so if you swap it out, nothing will happen.
Being that I'm an electronics guy, I can tell you , the only differnence from an LED and a regular diode is that one emmits light... so if you swap it out, nothing will happen.
Seatbelt / Aribag / ABS / E-brake / Etc..
Did not placed a diode (which was a thing i didnt know) and now the car mantains the Service Engine light on, not the SES. Throws some un-deleteable codes..
.. i guess i gotta pull that one now too..
03-24-2007, 12:09 PM
#23
Originally Posted by SScam68
Price for the wheel? P/N?
Was there anything additional you needed to buy for the install (other than the puller)?
Was there anything additional you needed to buy for the install (other than the puller)?
GRT-1080 $189.95
GRT-3196 $16.95
As long as you have the torx bit, nothing special besides the puller is needed.
That doesn't include fixing the issue with the airbag light .
03-24-2007, 09:47 PM
#25
Originally Posted by Luis Castellanos
I pulled all those LEDs:
Seatbelt / Aribag / ABS / E-brake / Etc..
Did not placed a diode (which was a thing i didnt know) and now the car mantains the Service Engine light on, not the SES. Throws some un-deleteable codes.. .. i guess i gotta pull that one now too..
Seatbelt / Aribag / ABS / E-brake / Etc..
Did not placed a diode (which was a thing i didnt know) and now the car mantains the Service Engine light on, not the SES. Throws some un-deleteable codes..
.. i guess i gotta pull that one now too..no, just replace the removed diodes with some non LED ones, and you'll have no more dash lights... you just have to put them on in the right polarity/direction.
Before you toss the cluster, try it. You have nothing to lose.
