BMR or Wolfe rear parachute setup?
#22
TECH Senior Member
iTrader: (21)
Joined: Nov 2001
Posts: 8,484
Likes: 0
From: Cecil County Raceway!!!
Originally Posted by TwoFast4Lv
Actually only the deploying mount goes up there
#23
Originally Posted by Fireball
it the "modified" version is anything like their typical one, then moving the "hole" above the license plate will cause what I mentioned
it goes exactly like it is in this picture, except you have a fold down plate mount, you fold it down slide the chute mount into the main mount bar on the car and put a 1/2 inch bolt through both tubes, you get to the bolt from under the car..... and no i still dont have any pics as i wont be near my pops computer until tomorrow..lol..
jay
#27
I don't know if they fixed it or not but on my wolfe chute mount, the bar for the actual chute mount was too close to the bumper. You can kinda see the camaro one posted above is the same way. It ended up rubbing all the paint off the bumper in one spot so now i'm going to have to repaint the bumper for a second time and figure out what to do to bring the chute mount out about another 1/2". I would just chop the mount off and re tig it but my chute mount is already powdercoated since I assumed it all fit correctly.
#29
I saw this car with it mounted up high.
#32
Here is my Wolfe chute set up....
#34
#35
#36
Ok I'll have to get a hold of them. How much did that set you back if you don't mind? And is that attached to the z wing or SS?
#37
I'll pm you what I paid, be prepared to wait for it, their each hand made and it takes a while. I have it attached to the stock Z28 rear spoiler. Joe @ Stenod was good to work with.