running without rear sway bar
Thread Starter
Teching In
Joined: May 2006
Posts: 14
Likes: 0
running without rear sway bar i was wonder how bad it would be to make a few shake down passes without a rear sway bar or drag bar?
the setup is a th400, 9 inch, qa1 single adj, adj lca's, adj panhard rod, sbc, adj relocated torque arm, built motor, 200 shot, weld's with 325 d/r's....
the car hasn't been to the track on it's current setup and i want to get some shake down passes made but haven't had the time or $$ to put the bar on. would it be ok? or should i wait?
the setup is a th400, 9 inch, qa1 single adj, adj lca's, adj panhard rod, sbc, adj relocated torque arm, built motor, 200 shot, weld's with 325 d/r's....
the car hasn't been to the track on it's current setup and i want to get some shake down passes made but haven't had the time or $$ to put the bar on. would it be ok? or should i wait?
i was wonder how bad it would be to make a few shake down passes without a rear sway bar or drag bar?
the setup is a th400, 9 inch, qa1 single adj, adj lca's, adj panhard rod, sbc, adj relocated torque arm, built motor, 200 shot, weld's with 325 d/r's....
the car hasn't been to the track on it's current setup and i want to get some shake down passes made but haven't had the time or $$ to put the bar on. would it be ok? or should i wait?
the setup is a th400, 9 inch, qa1 single adj, adj lca's, adj panhard rod, sbc, adj relocated torque arm, built motor, 200 shot, weld's with 325 d/r's....
the car hasn't been to the track on it's current setup and i want to get some shake down passes made but haven't had the time or $$ to put the bar on. would it be ok? or should i wait?
Thread Starter
Teching In
Joined: May 2006
Posts: 14
Likes: 0
do you think that would at least be enough so it would be safe? that was the issue i was worried about, and i won't have the cash for a drag bar till next week.
I almost put her in the wall more than once with the stock swaybar making less power than your 200 shot is going to make.
IMO no it's not safe. If your suspension is set up and it it lifts the front so you can't steer you'll be in the wall with that stock piece. JMHO.
IMO no it's not safe. If your suspension is set up and it it lifts the front so you can't steer you'll be in the wall with that stock piece. JMHO.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
