ls1 power
02-24-2011, 04:47 PM
#1
11 Second Club
Thread Starter
Join Date: Feb 2011
Location: pa
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
ls1 power my ls1 made 401rwhp and 366rwtq with just a ms4 and a ls6 intake 85mm tb and springs,headers and pipes..this dont seem to bad..has anyone hurd of better with this little done.
03-01-2011, 04:13 PM
#5
Teching In
Join Date: Feb 2009
Location: Richmond, CA
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Agreed. 381 hp/404 tq M6, with just catted long tubes, borla cat back, ram air, ud pulley and free mods on some tr6 plugs with a tune. that's n/a (no n2o) on a DynoDynamics which simulates load and correction factor to 77*F. what dyno??
03-02-2011, 01:29 PM
#7
Teching In
Join Date: Feb 2009
Location: Richmond, CA
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Technically yes; long story short it was a dealer installed package. There are q few select from the factory around if I'm not mistaken. Been a long time since I've read up on those threads though. Too bad they were dropped in 2000 and didn't keep the run going through 02. And oh yeah
ur down in sd? I'll be movin down there in a year and some change. OP - I also have a moser 9 alum housing with 4.11s and a steel driveshaft which will also account for some differences
ur down in sd? I'll be movin down there in a year and some change. OP - I also have a moser 9 alum housing with 4.11s and a steel driveshaft which will also account for some differences 
