whats wrong
whats wrong hi everybody
we just dynoed my friends car and i think its bit low what do you guys think?
the car is 99 m6 z28
mods:
flowtech long tube headers
true duals
ls6 intake
bbk 80mm throttle body
spec stg 3
almu flywheel
air lid (stock filter)
stock gears
no tune
the car dynoed 318rwhp 327rwtq is it good?
we just dynoed my friends car and i think its bit low what do you guys think?
the car is 99 m6 z28
mods:
flowtech long tube headers
true duals
ls6 intake
bbk 80mm throttle body
spec stg 3
almu flywheel
air lid (stock filter)
stock gears
no tune
the car dynoed 318rwhp 327rwtq is it good?
Trending Topics
He almost has full bolt ons i would say that isn't normal 99blkz28 he should be puting down more like 340 to 350. A tune would only help so much, check to make sure you have no air leaks and all the gaskets are on good.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
12 Second Club
Joined: Oct 2004
Posts: 63
Likes: 0
From: Kingwood, Tx
Originally Posted by ls1wannabe
He almost has full bolt ons i would say that isn't normal 99blkz28 he should be puting down more like 340 to 350. A tune would only help so much, check to make sure you have no air leaks and all the gaskets are on good.
TECH Addict
Joined: Jun 2005
Posts: 2,660
Likes: 14
From: England
Originally Posted by 99Blk Z28
No on a mustang dyno that is about right i have the same mods as he does but a tune as well. I put down 317 on a mustang dyno. On a dynojet which most people go by its around 345-350rwhp which is about right for the mods.
I agree totally, to many people read far too much into dyno numbers. And besides the mods listed are no where near FULL bolt ons, and there is no gaurantee they all make power.
the car is 99 m6 z28
mods:
flowtech long tube headers - yes these should imporve BHP, but if it started with 280-300 rwhp it has gained. Also a tune would be worth while.
true duals - what setup, you could easily loose power with a poor dual setup, it's all about flow rate. What mufflers are used.
ls6 intake - again it should make power, but was it definatley an LS6 intake? Many people have bought 2nd hand ones only to later find out it's an LS1 intake. A tune is vital
bbk 80mm throttle body - again no tune = pointless. Plus the stock TB actually flows pretty decently.
spec stg 3 almu flywheel - only minimal gains on a dyno, but should improve throttle response
air lid (stock filter) - again....
stock gears - so
no tune - probably the biggest culprit
the car dynoed 318rwhp 327rwtq is it good? - yes and no. A tune has the potential to find another 15-20rwhp. And there's no way a car with those mods should be making more than 340-350rwhp.
Plus as mentioned already, what type of dyno was it on? Even the tyre pressures could have effected the results by 1-3rwhp.
Originally Posted by venom ws7
hi everybody
true duals
ls6 intake
bbk 80mm throttle body
spec stg 3
almu flywheel
air lid (stock filter)
stock gears
no tune
the car dynoed 318rwhp 327rwtq is it good?
true duals
ls6 intake
bbk 80mm throttle body
spec stg 3
almu flywheel
air lid (stock filter)
stock gears
no tune
the car dynoed 318rwhp 327rwtq is it good?
TECH Junkie
Joined: May 2003
Posts: 3,050
Likes: 0
From: its fucking cold
K&N won't do a thing for the car, IMO they aren't worth the risks (over oiling and possibly ruining the MAF). If these numbers are from a Mustang dyno then they are right in line. A tune will always help, sometimes more than you think.