H/C Stock Bottom End 346 Dyno!
12-24-2006, 06:28 PM
#1
10 Second Club
Thread Starter
iTrader: (6)
Join Date: Jan 2006
Location: Hattiesburg, MS
Posts: 673
Likes: 0
Received 0 Likes
on
0 Posts
H/C Stock Bottom End 346 Dyno! The car is a 6-speed. It was tuned and dynoed about a month ago and I just got around to posting the graph. Tell me what you think. The graph is in MPH because on the RPM graph there is a big blank spot from where is spun the tires on the dyno. This is the only way you could see the whole graph. Enjoy! BTW this is on motor and a 150 shot!
12-24-2006, 06:38 PM
#3
10 Second Club
Thread Starter
iTrader: (6)
Join Date: Jan 2006
Location: Hattiesburg, MS
Posts: 673
Likes: 0
Received 0 Likes
on
0 Posts
Yea it leaned out so I ordered a racetronix setup. I haven't put it in yet but I have plans on doing it. BTW my car was built by the vette doctors and tuned by them when I first got it. I got it retuned by John @xXx motorsports and he said that their tune left a lot on the table. I gained a bunch of power down low. Notice the pretty decent torque curve. This is with cats, and a stock pulley!
