Numbers a little low???
Thread Starter
Staging Lane
Joined: Apr 2006
Posts: 69
Likes: 0
From: Tampa Bay, FL
Numbers a little low??? Well guys, finally got the car finished and put on the rollers. Took it down to HPE a few days before X mas and had them tweak it up a bit. Im happy with the performance but would have like to see it put a few more ponies down to the ground. Sorry for the poor quality photo. Its all I brought back with me. This one isnt even the final numbers but at least you can kinda see the curves.
The next run it pulled 401 rwhp and 375 rwtq at about 12.5 A/F. (which I thought could have been leaned out a bit more to around 13.0 being a NA motor and all) Is it just me or should a LS1 equipped with GTP stage II heads + Torqer V2 cam + Longube/ Cat Y+ Ls6 intake + ported throttle body be putting down a little bit more than that through an M6? I was shooting for around 420ish, I suppose 19hp/tq isnt too far away from my goals. There was no before dyno to compare to unfortunatley. All the work was completed at one time by a good buddy of mine while I was overseas. Comments/opinions welcome. Ill post the Vid of the Final pull as soon as it finishes uploading to photobucket.
-Zach
The next run it pulled 401 rwhp and 375 rwtq at about 12.5 A/F. (which I thought could have been leaned out a bit more to around 13.0 being a NA motor and all) Is it just me or should a LS1 equipped with GTP stage II heads + Torqer V2 cam + Longube/ Cat Y+ Ls6 intake + ported throttle body be putting down a little bit more than that through an M6? I was shooting for around 420ish, I suppose 19hp/tq isnt too far away from my goals. There was no before dyno to compare to unfortunatley. All the work was completed at one time by a good buddy of mine while I was overseas. Comments/opinions welcome. Ill post the Vid of the Final pull as soon as it finishes uploading to photobucket.
-Zach
