what you all think it might run tomorrow?
#1
Launching!
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: Cape Girardeau Missouri
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
what you all think it might run tomorrow?
taking the car to the track for the first time tomorrow with different setup
347 02 ls1
afr225's @59cc
236/242 .615 111LSA rapt cam
ls6 intake w/ stock TB
all other boltons, UD pulley, injectors, fuel pump, cutout, headers, etc.
fresh built a4 w/ 5000 converter
4.11 9" with drag radials & skinnies
strange DA coilovers on all 4 corners
not sure what my compression is but little higher than stock
i really have no clue it a 1/8 mile track
347 02 ls1
afr225's @59cc
236/242 .615 111LSA rapt cam
ls6 intake w/ stock TB
all other boltons, UD pulley, injectors, fuel pump, cutout, headers, etc.
fresh built a4 w/ 5000 converter
4.11 9" with drag radials & skinnies
strange DA coilovers on all 4 corners
not sure what my compression is but little higher than stock
i really have no clue it a 1/8 mile track
#2
Launching!
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: Cape Girardeau Missouri
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
went 7.3 with some traction and shifting issues, car wants to shift to 2nd at 7mph if i launch in overdrive!!! so for the time being i would take off in 1 and shift to 3rd once i got got past 60'
shift points set at 6400 for now (will be raised) and timing at 28* for now also
going to swap over to Hoosier slicks for next time, the old (hard) MT radials were not cutting it. but it was a t&t so the track prep was minimal.
shift points set at 6400 for now (will be raised) and timing at 28* for now also
going to swap over to Hoosier slicks for next time, the old (hard) MT radials were not cutting it. but it was a t&t so the track prep was minimal.
#5
Not to mention it runs .2 slower in OD.
Another thing you don't want to do is accelerate all the way through a burnout. Always let off before the wheels stop spinning.
#6
TECH Junkie
iTrader: (4)
I know I'm gonna be off slightly with my answer, but I'll be close. When you select D or lower, it turns on/opens a fluid pump outlet for hard acceleration. Whereas in OD, that additional fluid isn't being flowed where it needs to be.
Not to mention it runs .2 slower in OD.
Not to mention it runs .2 slower in OD.