Kingc8r

iTrader: (21)

We're waiting for result, impatiently might I add lol

ramairetransam

iTrader: (18)

numbers???


454hp 437tq

poltergeist 02

iTrader: (65)

472/428 with the converter locked.

poltergeist 02

iTrader: (65)

Any updates Jake?

86Z28USAF

iTrader: (1)

i really wanna see what this is going to do?

JakeFusion

iTrader: (7)

Been out of town working.

Talked to Geoff today. Car isn't exactly idling at the moment. Wanted to get it at least idling before I took it in for a dyno session. But I think I know what the issue is. Working to resolve now.

maroonls1z

Let me know how the FTP lid/texas speed ls7 MAF combo works for ya. I've heard it's hard to get it to work right on low cubes because they don't flow enough air but I'd like to get one and see how it goes if yours works out

JakeFusion

iTrader: (7)

So, in what has been the longest build ever (interrupted by two 3-month long proposals where I was out of town a lot and my house flooding), I finally have a dyno day: August 26. I'll update the thread when I have numbers.

JakeFusion

iTrader: (7)

Dyno day has been pushed back: September 12.

maroonls1z

Big day, and I hear yah on the long build... Being doing mine about a year

JakeFusion

iTrader: (7)

Had to cancel. My MAP sensor went apeshit. Hard to dyno with an SD tune when the only sensor that controls the car is hosed... ugh

thunderstruck507

iTrader: (18)

run down to AZ and grab one?

JakeFusion

iTrader: (7)

Lol. I got the manifold off. It's so damn hot that's as far as I got.

thunderstruck507

iTrader: (18)

you have to take the manifold off?

I knew you guys had it bad but damn...I figured you could reach back there blind and pull it out

I take my engine bay for granted haha. I can even get the top bellhousing bolt from the top with a wrench if I lay on the engine

JakeFusion

iTrader: (7)

I'm moving it to the front. I could I guess just put a hose on the end, but it seems like reading off the front would be better than reading out of a hose.

Just need to find something to plug the old hole. Blah.

Pharcyde50

iTrader: (11)

Interested to see your numbers I have a very similar build I need to get dynod. Got the SD street tuned worked out pretty well here. I've got the same cam but with .630 lift.

JakeFusion

iTrader: (7)

With the 370 and M6 you should do better.