Hanover, PA Sonic meet #2
#42
TECH Enthusiast
Thread Starter
iTrader: (7)
Join Date: Feb 2003
Location: Hanover, PA
Posts: 587
Likes: 0
Received 0 Likes
on
0 Posts
Some of the guys are going to Pharro Perf. on Gitts Run Rd before the meet & then everyone will be at the Sonic's around 1:30. got my car polished up & ready to go!!
#45
11 Second Club
iTrader: (1)
Maybe we can set something up with Bryan at Pharro for a cookout dyno day in the near future...I haven't talked to Bryan about this yet, but it might be cool to get a bunch of cars on the dyno and eat some badly cooked food...The Mustang dyno has a 1/4 mile simulator which is a blast to drive on...No 60' issues when you're strapped to the rollers! And some folks may like to see what their cars are putting down at the wheels...Just spit balling ideas at this point...If there's any interest I'll call Bryan later and see what his thoughts are...
--Alan
--Alan
#46
TECH Enthusiast
iTrader: (13)
Join Date: Jan 2006
Location: Parkton, Md.
Posts: 658
Likes: 0
Received 0 Likes
on
0 Posts
Maybe we can set something up with Bryan at Pharro for a cookout dyno day in the near future...I haven't talked to Bryan about this yet, but it might be cool to get a bunch of cars on the dyno and eat some badly cooked food...The Mustang dyno has a 1/4 mile simulator which is a blast to drive on...No 60' issues when you're strapped to the rollers! And some folks may like to see what their cars are putting down at the wheels...Just spit balling ideas at this point...If there's any interest I'll call Bryan later and see what his thoughts are...
--Alan
--Alan
Mike G.
#54
TECH Apprentice
iTrader: (4)
Join Date: Jan 2006
Location: Harrisburg, PA
Posts: 381
Likes: 0
Received 0 Likes
on
0 Posts
I think he is better then McNews. He is very picky about the work he does. If its not done right he will make it right. Everything I have seen him do has been top notch. His labor rates vary depending on what he is doing. He would rather quote out things on a personal basis.