1fastbird's turbo toy is alive
#23
TECH Fanatic
Thread Starter
iTrader: (12)
Join Date: Jul 2004
Location: Roanoke Va
Posts: 1,234
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure of the exact specs but I'm pretty sure its a 2.4L stroker out of an Eagle Talon with a 20g turbo and 150 shot of NOS. LOL
Its actually a ls2 402 low compression with twin tc76's and Th400. This was just the initial tune on low boost to get the car drivable. It has quite a bit more in it for sure.
I think Chad is going to have fun at this level for a little while and then turn up the wick.
Its actually a ls2 402 low compression with twin tc76's and Th400. This was just the initial tune on low boost to get the car drivable. It has quite a bit more in it for sure.
I think Chad is going to have fun at this level for a little while and then turn up the wick.
#24
TECH Fanatic
iTrader: (12)
Join Date: Jan 2002
Location: York, PA
Posts: 1,249
Likes: 0
Received 0 Likes
on
0 Posts
Its actually a ls2 402 low compression with twin tc76's and Th400. This was just the initial tune on low boost to get the car drivable. It has quite a bit more in it for sure.
I think Chad is going to have fun at this level for a little while and then turn up the wick.
#25
TECH Fanatic
Thread Starter
iTrader: (12)
Join Date: Jul 2004
Location: Roanoke Va
Posts: 1,234
Likes: 0
Received 0 Likes
on
0 Posts
It would be funny to see Chad open the shoot on the Mexican mile and still pull away from you.
#26
#28
#31
9 Second Club
iTrader: (22)
Join Date: Mar 2008
Location: Lancaster,Pa.
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
The initial timing was off by close to 20 degrees. Even though we were commanding 18 degrees advance it wasn't even close. Meaning that during our dyno runs we were at 0 degrees of timing. Lucky we didn't hurt the motor!!! Probably at least another 100 hp at 12 psi.
#35
TECH Senior Member
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
I helped him with the car for about 8hr today...we rebuilt one of his downpipes for more clearance and the car is now scaled and suspension is setup...
car wasn't near as heavy as I was expecting
car wasn't near as heavy as I was expecting
#40
9 Second Club
iTrader: (22)
Join Date: Mar 2008
Location: Lancaster,Pa.
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
Have a few loose ends to tie up and then I'm ready for some shakedown passes. I gotta thank Kris (2ktransam) and Brian (Fireball) for all the help and advice they have given so far. Couldn't have finished this thing without them two guys. We will soon see what a 402 and twin tc76's can do!!!!!