Progress made, pics inside
Originally Posted by JL ws-6
where's the driveshaft?
You think Greg's still gonna want to come get my car this weekend?
You think Greg's still gonna want to come get my car this weekend?
good question, i will have to call him tonight, remind me, i got to work tomorrow hopefully just for a few hours in the AM then its out to
Originally Posted by Humvee z28
u can never change ur fuel filter or any other fluids enough. i do a fuel filter every 6 months and it only takes 10 minutes to swap. just my opinion
i know its a joke
Thread Starter
Joined: May 2005
Posts: 9,830
Likes: 2
From: Wallingford CT
Originally Posted by thechef
why didnt you get that stuff from specialized with his discount?
He will be delivering it on Tuesday, its all good. I just have to wait for the plug wires and Brass plug.
I got the axles in, took me 20 minutes and I took my time. When I did the moser in RedScreaminZ's car it was such a Pain in the ***. With the E brake hardware. I turned it down so there wasnt any pre-load. put the axle in the rear, then took a small pry bar and pushed up on the ebrake ring then pulled toward me and over the axle hub and studs, then put the T-bolts in with the hardware. I also had to grind on the ABS sensor due to the axles but its all together.
I would like to get out there tommorrow to clean up and organize the tools. Then see what I need to get the cat back in place.
Snow blowing took forever today
im cold, im going to eat. LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
11 Second Club
Joined: Feb 2004
Posts: 936
Likes: 0
From: Fort Greely, Alaska
Originally Posted by thechef
i know its a joke
Thread Starter
Joined: May 2005
Posts: 9,830
Likes: 2
From: Wallingford CT
omg snow sucks, its so wet and heavy it broke the plastic thrower so all the snow does is go up. I had to do it by hand, I am so beat up and tired im not doing **** today. I dont care. im going to take a shower.
I am so beat up and tired im not doing **** today. I dont care. im going to take a shower.
JL, sorry I didnt call- I just havent been anywhere near that area of the state lately. Its like a 25+ minute drive from my house, and Ive been working longer than my shifts at work, so Im quite beat as well.
If possible, Ill just drop off the lugs @ BSM's house on tuesday when I come with the goods.
Thread Starter
Joined: May 2005
Posts: 9,830
Likes: 2
From: Wallingford CT
I got a little more done. Mocked the Corsa up. Since it was made for the LT1, most of the hangers are the same and in similar places, just not exact. I zip tie everything up. The driver side tip looks perfect where the passanger side looks a little tweaked. I will have to get that fixed.
Over all I think it will do the job. Tuesday the Headers go in and the y pipe gets mocked up.. Then most likely wednesday the rear end bolts in. Also other minor stuff like the fluids, brakes, filters, and make sure the exhaust is secure.
Over all I think it will do the job. Tuesday the Headers go in and the y pipe gets mocked up.. Then most likely wednesday the rear end bolts in. Also other minor stuff like the fluids, brakes, filters, and make sure the exhaust is secure.