Finally!!!!!!!!!!!!!!!!!!!!!
Thread Starter
TECH Junkie
iTrader: (12)
Joined: Jun 2002
Posts: 3,151
Likes: 0
From: Fall River, MA
Finally!!!!!!!!!!!!!!!!!!!!! I drove my SS today with the TH-400. I was waiting on my cousin to make me brackets for the light weight seat. I finally figured out what 2 wires to splice together to make the car start. It's the blue clip with the purple and green wire in case anyone needs to know 
My impression:
I need a manual valve body!!!!! the tranny is still vacumn modulated
and it doesn't like me I guess cause I couldnt get the thing to shift for nothing. I kept bouncing of the limiter.
One thing for sure is, this car is gonna rip
I can tell its gonna be sick
Marco
My impression:
I need a manual valve body!!!!! the tranny is still vacumn modulated
and it doesn't like me I guess cause I couldnt get the thing to shift for nothing. I kept bouncing of the limiter. One thing for sure is, this car is gonna rip
I can tell its gonna be sick
Marco
Ive driven a TH350 personally and have been driven in a TH400 car that runs mid 10's on motor, its a fun trans, I just hated the fuel economy.
Get that manual valve body in asap!!
Get that manual valve body in asap!!
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Thread Starter
TECH Junkie
iTrader: (12)
Joined: Jun 2002
Posts: 3,151
Likes: 0
From: Fall River, MA
Only thing you need is a LS1 specific converter, cross member from BMR, and you should cut the ears off the bell housing.
It's pretty basic
Thread Starter
TECH Junkie
iTrader: (12)
Joined: Jun 2002
Posts: 3,151
Likes: 0
From: Fall River, MA
Thread Starter
TECH Junkie
iTrader: (12)
Joined: Jun 2002
Posts: 3,151
Likes: 0
From: Fall River, MA
Yeah, once I get the new valvebody I'll be ready to rip 
Speedo does not work but that's easy
You take the VSS sensor and the drivers side abs sensor and splice them together, then in the tune you set the rear gear ratio at 2:76 (if its a M6) set the tire size to the front wheel tire size and bam theres your speedo
Speedo does not work but that's easy
You take the VSS sensor and the drivers side abs sensor and splice them together, then in the tune you set the rear gear ratio at 2:76 (if its a M6) set the tire size to the front wheel tire size and bam theres your speedo