Hello all, I am looking for an LS1 engine for mock-up/fabrication purposes that I could borrow at the end of the month (Sept) through the beginning of oct. All I would need is the block and a set of heads, and any of the LS engines would do 4.8, 5.3, 6.0, etc. engine can be damaged as long as the mounting points are intact. I am bringing my car down from PA and sending my LQ4engine to the maching shop for a build, and while it is there, I was hoping to be able to have the fabrication work done on a spare engine to reduce the down-time. Forum member 2JZFC will be doing the fab work...
Thanks in advance, mike

 

Where in Orlando are you?

I've got 2.. 4.8 and a 5.3

 

Thanks for the reply :-)
The car will be in east Orlando, near Bithlo (actually Chuluota - if I spelled that correctly)...
Either one would work for me. I will be down at the end of the month 24th-25th or so if you would be willing to allow me to hold one hostage for a short time to mock up mounts and plumbing...
Mike

 

Should be close by. I am in Pickett Downs off Fort Christmas Rd. Probably bumped into each other several times at the track

 

Hehe.. I'm in picket downs too....

 

I got that bigass white/green F350. I'm sure I've seen you around...

 

HUGE thanks to k5383 for coming through with a mockup longblock!!
Let the build begin!!

 

Hey Z those heads you have are mine and I don't mind you borrowing them but I need them like ASAP for my mock up so when your done I could really use them. Not to sound like a dick or anything lol. K383 didnt realize I would need them this soon.