BFH / fender roll
I BFH my inner wheel wells to fit my 335 tires......they aren't on yet. I have to still cut the bump stop mount out and those 3 ridges above it. Then weld in a flat 16 gauge steel plate. Install offset LCAs and put them on.
I'm not rolling my fender lips.....no need.
.
I'm not rolling my fender lips.....no need.
.
My 315s are on, but a slit or slice of rubber was taken out by the fender i believe. Would rolling be necessary? I dont have a PHB. If the BFH mod is needed what is the method used?
On The Tree
Joined: May 2014
Posts: 179
Likes: 0
From: FortLauderdale/Orlando
If it's lowered you'll need the adjustable phb for sure. I had to roll the fenders, cut the bump stop mounts and do the bfh mod for 315's. There's a few pics of where I had to hammer in this thread.
https://ls1tech.com/forums/chevrolet...-ss-build.html
https://ls1tech.com/forums/chevrolet...-ss-build.html
