Exhaust shop
Thread Starter
TECH Enthusiast
iTrader: (12)
Joined: Nov 2004
Posts: 591
Likes: 0
From: Palmetto, Florida
Exhaust shop Anyone know of a decent exhaust shop in the bradenton/sarasota/palmetto area that could fab me up and install a cutout in my i-pipe?? just put headers on, and really wanna hear my car scream.
anyone with a sawzall and a welder should be able to install a cutout
just get one from a sponsor or summit or something and take it to your local muffler place.
might have to try a few since you dont have cats, some of them bitch about that
just get one from a sponsor or summit or something and take it to your local muffler place.
might have to try a few since you dont have cats, some of them bitch about that
www.revxtreme.com - give them a call. ask for "dino" pronounced deeno. also a sponser here on the board and in brandon, fl
Thread Starter
TECH Enthusiast
iTrader: (12)
Joined: Nov 2004
Posts: 591
Likes: 0
From: Palmetto, Florida
Anyone have a preference for cutouts? I dont want an electric one because I hear they break, but I also dont wanna have on that I cant uncap unless I jack it up. Is there somewhere I can put it that I can uncap by just reaching under?? Should i buy one with the wingnuts or the one with the cable like from Jeg's???
Get the flowtech race pack it comes with two mount them one on each side of the y pipe, I have got about 8 different exhaust systems done at stacy's on 12th street in sarasota, they did my whole dual system for like 250, I think to do both cutouts was like 40 bucks or something.
Thread Starter
TECH Enthusiast
iTrader: (12)
Joined: Nov 2004
Posts: 591
Likes: 0
From: Palmetto, Florida
how hot do the cutouts get?? like, if i run them closed for awhile, and then decide to uncap them, will i burn my hand, or can i use a rag or sumthin and not get burnt. i really dont wanna get an electric cutout. thanks again, i'll be checkin out stacy's and let them know you referred me. is there any specific name i should tell them, or just TAdriven98?? what size cutouts should i get for my pacesetter ory???(3 inches right?)
Maybe refer to me as kid with the white trans am with true duals or brett??? As far as I know they give everyone a fair price, I always kept a rag or towel or something like that because they will get hot and also get a few extra wing nuts because they will blow off from time to time unless you tighten them all the time.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo