69 Camaro For Sale
#1
69 Camaro For Sale
Starting with issues,
Pin hole leak in radiator (have new aluminum radiator coming from Jegs) and comon rust bubbles around the wheel wells and small patch in bottom of trunk pan. No rust underneath or anywhere else. Rear end needs posi, it is currently a 10 bolt. Steering box is hitting dead spots when it gets really hot, working on resolving issue now. Will fix before sale.
Does not leak any fluids. I put about 1,800 miles a year on this car and all below parts were put on this year so everything is new and in very good shape.
Has power steering and brakes.
Just put on Ram clutch, pressure plate, friction disk and flywheel about 200 miles ago. MSD 6AL box, MSD Probillet dist, MSD Blaster 2 same time as clutch. Replaced tranny fluid with clutch install. Tranny is a Muncie M21 4 spd. Engine is a 4 bolt main crate 350, iron block and heads. Hooker supercomp long tube ceramic headers into dual flowmaster delta 40's. 17X8 all around TT II's, Weiand 144 supercharger with 2.5" upper running 10-12 lbs of boost, no detonation pump gas no issues. Demon 725 elec choke vac secondaries carb. with a K&N on top. Proform electric fan with thermostat. Front sub frame was torn completley down and rebuilt with new upper and lower A arm bushings, new upper and lower ball joints, new idler arm, inner outer and center tie rods, new hub/rotors, new calipers, new pads, new wheel bearings. KYB shocks, Hotchkis sprins (2" lower) Just put in new plugs NGK V power gapped at 48.
Engine, brakes, ball joints/tie rods, wheel hub,steering box and tranny all have new fluids filled with synthetic.
Engine starts first bump after sitting a week and idles perfectly just under 1k rpms.
Havent dynoed it yet to know what it puts down.
Interior is in great shape.
$23,500 obo.
Pin hole leak in radiator (have new aluminum radiator coming from Jegs) and comon rust bubbles around the wheel wells and small patch in bottom of trunk pan. No rust underneath or anywhere else. Rear end needs posi, it is currently a 10 bolt. Steering box is hitting dead spots when it gets really hot, working on resolving issue now. Will fix before sale.
Does not leak any fluids. I put about 1,800 miles a year on this car and all below parts were put on this year so everything is new and in very good shape.
Has power steering and brakes.
Just put on Ram clutch, pressure plate, friction disk and flywheel about 200 miles ago. MSD 6AL box, MSD Probillet dist, MSD Blaster 2 same time as clutch. Replaced tranny fluid with clutch install. Tranny is a Muncie M21 4 spd. Engine is a 4 bolt main crate 350, iron block and heads. Hooker supercomp long tube ceramic headers into dual flowmaster delta 40's. 17X8 all around TT II's, Weiand 144 supercharger with 2.5" upper running 10-12 lbs of boost, no detonation pump gas no issues. Demon 725 elec choke vac secondaries carb. with a K&N on top. Proform electric fan with thermostat. Front sub frame was torn completley down and rebuilt with new upper and lower A arm bushings, new upper and lower ball joints, new idler arm, inner outer and center tie rods, new hub/rotors, new calipers, new pads, new wheel bearings. KYB shocks, Hotchkis sprins (2" lower) Just put in new plugs NGK V power gapped at 48.
Engine, brakes, ball joints/tie rods, wheel hub,steering box and tranny all have new fluids filled with synthetic.
Engine starts first bump after sitting a week and idles perfectly just under 1k rpms.
Havent dynoed it yet to know what it puts down.
Interior is in great shape.
$23,500 obo.