Project V6+2 mod
02-19-2008, 06:25 PM
#1
TECH Enthusiast
Thread Starter
iTrader: (15)
Join Date: Nov 2006
Location: Jax, FLA
Posts: 706
Likes: 0
Received 0 Likes
on
0 Posts
Project V6+2 mod OK,
Finally got off my *** and took some pics of my project. Didn't get all the pics,but here is most of them and my slow progress.
(excuse the home,lol..)
Here is the donor Z28:
The leftovers after 4hrs of hacking
there is more,but this is the main reason for the purchase)
And here is my $250 roller:
since there is room i did a quick touch up in the engine bay. (kinda a rush job,but more to do)
The only real problem with the roller (the door and rocker,but hey it was $250)
So, now I am just about $1800 away from having a running driving hopefully 11sec camaro.
I don't plan on putting any Z28 bages on it,but the roof is goin to be black, and "Berger" panel along with a sunocco hood and ss spoiler are in the works along with ZR1's or 10spokes...But performance then looks
I hope to be done by end of March.
Finally got off my *** and took some pics of my project. Didn't get all the pics,but here is most of them and my slow progress.
(excuse the home,lol..)
Here is the donor Z28:
The leftovers after 4hrs of hacking
there is more,but this is the main reason for the purchase)And here is my $250 roller:
since there is room i did a quick touch up in the engine bay. (kinda a rush job,but more to do)
The only real problem with the roller (the door and rocker,but hey it was $250)
So, now I am just about $1800 away from having a running driving hopefully 11sec camaro.
I don't plan on putting any Z28 bages on it,but the roof is goin to be black, and "Berger" panel along with a sunocco hood and ss spoiler are in the works along with ZR1's or 10spokes...But performance then looks
I hope to be done by end of March.
02-19-2008, 07:18 PM
#4
TECH Enthusiast
Thread Starter
iTrader: (15)
Join Date: Nov 2006
Location: Jax, FLA
Posts: 706
Likes: 0
Received 0 Likes
on
0 Posts
So far I have FLP long tubes. Waiting on a Y pipe, Edelbrock TQ arm,and LS6 heads.
And then I need a Lid, Built Trans w/ 4k stall, LCA's,Cam,Pushrods,oil pump,timing set,muffler set-up, and some tires for the wheels...Then it'll be good to go for now. Then the rest of the modding will begin.
I am hopeing for 11's on motor,then spray low 11's or maybe 10's if I can drive,lol
And then I need a Lid, Built Trans w/ 4k stall, LCA's,Cam,Pushrods,oil pump,timing set,muffler set-up, and some tires for the wheels...Then it'll be good to go for now. Then the rest of the modding will begin.
I am hopeing for 11's on motor,then spray low 11's or maybe 10's if I can drive,lol
