well its about time (vid inside)
The Best V8 Stories One Small Block at Time
I just ran an 8.87 on 16-inch radials last week , I don't own a trailer and always drive my car to the track , and my car is also a pig at 3700+lbs with me in it , the three of us should meet up at MIR next year and have a little friendly street car shootout
. My car has more in it as it sits , and I may upgrade to an air to water IC and a 6-bolt set up over the winter .
Last edited by STEALTH TURBO C5; Nov 28, 2008 at 09:41 PM.
I just ran an 8.87 on 16-inch radials last week , I don't own a trailer and always drive my car to the track , and my car is also a pig at 3700+lbs with me in it , the three of us should meet up at MIR next year and have a little friendly street car shootout
. My car has more in it as it sits , and I may upgrade to an air to water IC and a 6-bolt set up over the winter .
Dave and I usually run against each other at the MACA vs. EFA shootout that is held twice a year at MIR. You should definitely try to make it as it is a really fun event.
Hope to see you there.
i have an rc car power connector to the pump, so that was just an unplug and tuck the harness away.
the fittings under the dead pedal in the drivers floorboard were capped after i pumped some antifreeze to the intercooler.
the tank, hoses, pump etc. came out and got rinsed with some antifreeze/water as well.
If so can ya email it to me.... i like how ya did that...
You still running the heat exchanger when u run that tank setup???
tank was from tank depot
pump is a rule from grainger
fittings and hoses from home depot








