procharger crank pinning tool parts needed

Reply Subscribe

Thread Tools

Search this Thread

Nov 27, 2008 | 09:30 AM

red83

Thread Starter

TECH Resident

iTrader: (64)

Joined: Jul 2005

Posts: 908

Likes: 0

From: sneaking in your back door as you leave!/cartersville ga

procharger crank pinning tool parts needed

i need to borrow the 2 bushings and i need to buy one pin for the snout.

the kit i just got didnt have the bushings included and the pins are to larger for the ati dampner

i know this isnt the wanted section, but for what i need its the best way to find what i need

MODS, show me mercy

Last edited by red83; Nov 27, 2008 at 09:36 AM.

Nov 27, 2008 | 09:57 AM

Z06PSI

TECH Addict

iTrader: (33)

Joined: Jul 2002

Posts: 2,647

Likes: 1

From: Thomson, GA

I have some 1/4" solid pins.

Nov 27, 2008 | 10:12 AM

red83

Thread Starter

TECH Resident

iTrader: (64)

Joined: Jul 2005

Posts: 908

Likes: 0

From: sneaking in your back door as you leave!/cartersville ga

i think i need the 3/16" pins. i will go measure my balancer in a few

Nov 28, 2008 | 07:39 PM

red83

Thread Starter

TECH Resident

iTrader: (64)

Joined: Jul 2005

Posts: 908

Likes: 0

From: sneaking in your back door as you leave!/cartersville ga

anybody?

and i will measure the pins tonight

Nov 28, 2008 | 08:08 PM

Z06PSI

TECH Addict

iTrader: (33)

Joined: Jul 2002

Posts: 2,647

Likes: 1

From: Thomson, GA

I used a ATI kit and it was 1/4". Bought a drill bit and 50 pins from Fastenal so I still have a lot. And they are solid, not roll. You could always PM madeouttaglas over on CF and he has the fixture and some of my pins I think.