Picture thread of my EZ 94mm KYTP Build!!
08-17-2009, 09:02 AM
#108
Went out yesterday and did some tuning. We put appx. 50-60 miles on the car. Had a few small issues along the way. Nothing a small bottle of water didn't cure
. And @12lbs of boost @4300rpm the TB gasket blew out. 
LOL! My only concern is the water temps seem to be a little higher than I like. Stayed around 210-215deg. during cruising and maybe climbed up 5 deg. sitting at the stop lights. Other than that, the car feels good. I like the TH400
so far. The good news is the car is tuned with almost "0" o2 correction and now I can don't have to worry about the tune being off while driving. Time to put some good break in miles on her.
. And @12lbs of boost @4300rpm the TB gasket blew out. LOL! My only concern is the water temps seem to be a little higher than I like. Stayed around 210-215deg. during cruising and maybe climbed up 5 deg. sitting at the stop lights. Other than that, the car feels good. I like the TH400so far. The good news is the car is tuned with almost "0" o2 correction and now I can don't have to worry about the tune being off while driving. Time to put some good break in miles on her.
09-25-2009, 12:51 PM
#112
No not yet.possibly going to the track next week to do some tuning and suspension tuning. I went to the dyno last week, and basicly had "0" timing since I forgot to sync the BS3 and motor together, and made close to 700rwhp on 6psi. Now with the timing acurate, I am pretty sure I added another 100rwhp with 15deg. of timing still at 6psi. It's just a #, the track will tell all.
09-25-2009, 12:58 PM
#113
No not yet.possibly going to the track next week to do some tuning and suspension tuning. I went to the dyno last week, and basicly had "0" timing since I forgot to sync the BS3 and motor together, and made close to 700rwhp on 6psi. Now with the timing acurate, I am pretty sure I added another 100rwhp with 15deg. of timing still at 6psi. It's just a #, the track will tell all.
I dont even think the Turbo is working with 6psi
and low timing
Tell you have a dyno vid or
GOOD LUCK.
10-04-2009, 07:44 PM
#116
No track times yet. I will be in Montgomery this weekend for the testing and tuning. I did get my new rear end installed and the roll cage is in as well. Just going over the car with a fine tooth comb before this weekend and then off to the Shootout the following weekend. Installing the Parachute this week as well.
10-05-2009, 03:52 PM
#118
No track times yet. I will be in Montgomery this weekend for the testing and tuning. I did get my new rear end installed and the roll cage is in as well. Just going over the car with a fine tooth comb before this weekend and then off to the Shootout the following weekend. Installing the Parachute this week as well.
10-05-2009, 05:45 PM
#120
The old motor kicked a couple of rods after a 100+ dynos...countless street passes and track passes. He got this setup to not push water and be able to put the a/c on before summer comes back around. Mainly he wanted a 8.50 sec street car with a/c. He has the hardware to kick some *** reliably now....and still drive all over atlanta with the rest of us street cars 
He got his emissions today and then its off to the track this weekend...2 days for shakedown passes and maybe a little cash 
He got his emissions today and then its off to the track this weekend...2 days for shakedown passes and maybe a little cash