Oldsmobility85

iTrader: (1)

I was wondering if anyone was using or knew anyone using k member spacers for added engine clearance. I herd that 4th gen guys were using them to install magnuson chargers? I have a carb'd small block that I am trying to get some more hood clearance and access to work on engine and was wondering how cars drove after installing and how the drive shaft load angles ended up. I was thinking 1/2" spacers?

Thank you for any input.
Drew.

farmdawg

My car had 3/4" spacers on the K-member and after installing them I noticed no difference in driveability or driveshaft angle effects on the car. Steering reaction was same as before too. It went straight after letting of the sterring wheel, so I didn't notice any change in alignment or any issues with the alignment after putting the spacers on.

So.jerZ-28

iTrader: (20)

1/2" spacers in mine, no difference here either!

Oldsmobility85

iTrader: (1)

Awesome guys thank you. Did you not run any spacers under the trans cross member either?